Honda Transalp XL700V Manual page 208

4. Engine Stop Relay Inspection 2
Turn the ignition switch OFF.
Jump the engine stop relay connector terminals.
Connection: Black/white – Red/blue
Turn the ignition switch ON and engine stop
switch " ".
Measure the voltage at the ECM 33P connector
and ground.
Connection: A4 (+) – Ground (–)
Is there the battery voltage?
YES – Inspect the engine stop relay (page 5-
75).
NO – Open circuit in power input line (Black/
white, Red/blue or Red/green) between
the battery and the ECM.
REMOVAL/INSTALLATION
EXCEPT E, F TYPE
Remove the left side cover (page 2-4).
Disconnect the ECM 33P connectors.
Remove the rubber band and the ECM.
Installation is in the reverse order of removal.
FUEL SYSTEM (PGM-FI)
RELAY TERMINAL
R/Bu
ECM 33P (BLACK) CONNECTOR
(Wire side/female terminal)
ECM 33P (GRAY) CONNECTOR
RUBBER BAND 33P (BLACK) CONNECTOR
Bl/W
JUMPER WIRE
A4
5-77