Honda Transalp XL700V Manual page 390

Coat a new O-ring with fork fluid and install it into
the fork cap groove.
Hold the fork cap securely and install it into the fork
Be careful not to
tube.
cross-thread the
fork cap.
Tighten the fork cap
after installing the
fork tube into the
fork bridge.
Install the stopper ring into the groove of the fork
slider, being careful not to scratch the fork tube slid-
ing surface.
Coat a new dust seal lips with fork fluid and install
it.
INSTALLATION
Install the fork leg into the steering stem and top
Route the wires,
bridge.
hoses and cables
properly (page 1-21)
Align the top end of the fork tube with the upper
surface of the top bridge.
Tighten the bottom bridge pinch bolts to the speci-
fied torque.
TORQUE: 34 N·m (3.5 kgf·m, 25 lbf·ft)
FRONT WHEEL/SUSPENSION/STEERING
O-RING
STOPPER RING
Align
TOP BRIDGE
PINCH BOLTS
FORK CAP
DUST SEAL
FORK
13-29