Honda Transalp XL700V Manual page 207

FUEL SYSTEM (PGM-FI)
2. ECM Ground Line Inspection
Turn the ignition switch OFF.
Check for continuity between the ECM 33P con-
nectors and ground.
Connection: A23 – Ground
TOOL:
Test probe
Is there continuity?
YES
NO
3. Engine Stop Relay Inspection 1
Turn the ignition switch OFF.
Remove the seat (page 2-4).
Open the fuse box and remove the engine stop
relay.
Turn the ignition switch ON and engine stop
switch " ".
Measure the voltage at the engine stop relay ter-
minal of the wire harness side.
Connection: Black (+) – Red/white (–)
Is there battery voltage?
NO
YES
5-76
A24 – Ground
B4 – Ground
07ZAJ-RDJA110
– Replace the ECM with a new one, and
recheck; for Key Registration Proce-
dures (page 21-4).
– Open circuit in Green line
– • Inspect the bank angle sensor (page
5-73).
• Inspect the engine stop switch (page
20-21).
• Inspect the ignition switch (page 20-
20).
• Blown fuse (MAIN 30 A)
• Blown fuse (BANK ANGLE 10 A)
– GO TO STEP 4.
ECM 33P CONNECTORS
(Wire side/female terminal)
A24
A23
ENGINE STOP RELAY
R/W
Bl
B4
RELAY TERMINAL