Honda Transalp XL700V Manual page 484

Hide thumbs Also See for Transalp XL700V:

Table of Contents

3. Turn the ignition switch OFF and remove the

jumper wire.

CLEANING PROBLEM CODE

1. Short the wire terminals of the ABS service check

3P (Natural) connector with a jumper wire with

the ignition switch turned OFF in the same man-

ner as retrieval.

Connection: Brown/white – Green

2. Turn the ignition switch ON and engine stop

switch " " while squeezing the brake lever. The

ABS indicator should come on for 2 seconds and

3. Release the brake lever immediately after the

ABS indicator is off. The ABS indicator should

4. Squeeze the brake lever immediately after the

ABS indicator is on. The ABS indicator should go

5. Release the brake lever immediately after the

ABS indicator is off.

When code erasure is complete, the ABS indica-

tor blinks 2 times and stays on.

If the ABS indicator does not blink 2 times, the

data has not been erased, so try again.

If the ABS indicator blinks 2 times and blinks,

faulty ABS system, go to ABS troubleshooting

(page 16-13).

6. Turn the ignition switch OFF.

ANTI-LOCK BRAKE SYSTEM (ABS)

ABS SERVICE CHECK

ABS SERVICE CHECK

ABS INDICATOR

Show Quick Links

Chapters

Table of Contents

Transalp xl700va