Fuel Pump - Honda Transalp XL700V Manual

FUEL SYSTEM (PGM-FI)
Relive the fuel pressure and remove the quick con-
nect fitting (page 5-54).
Connect the hose attachment to the fuel pump joint.
TOOL:
Hose attachment, 8 mm/9 mm
Place the end of the hose into an approved gasoline
Wipe spilled
container.
gasoline out of the
container.
Temporarily connect the battery negative (–) cable
to the battery.
Turn the ignition switch ON, engine stop switch " "
for 10 seconds.
Measure the amount of fuel flow.
Amount of fuel flow:
189 cm
/10 seconds at 12 V
If the fuel flow is less than specified, inspect the fol-
lowing:
– Fuel pump (page 5-58).
– Clogged fuel filter (Assembly of the fuel
pump:page 5-59)
Connect the quick connect fitting (page 5-55).

FUEL PUMP

INSPECTION
• Refer to the fuel level sensor inspection (page 20-
16).
Turn the ignition switch ON, engine stop switch " "
and confirm that the fuel pump operates for a few
seconds.
If the fuel pump does not operate, inspect as fol-
lows:
Turn the ignition switch OFF.
Remove the right side cover (page 2-4).
Disconnect the fuel pump 3P (Natural) connector.
Turn the ignition switch ON, engine stop switch " "
and measure the voltage at the wire side.
Connection: Brown (+) – Green (–)
There should be battery voltage for a few seconds.
If there is battery voltage, replace the fuel pump.
If there is no battery voltage, inspect the following:
– Open circuit in Brown wire and/or Green wire
– Fuse 20 A (FI)
– Fuse 10 A (BANK ANGLE)
– Main fuse 30 A
– Fuel pump relay (page 5-61)
– Engine stop relay (page 5-75)
– Engine stop switch (page 20-21)
– Ignition switch (page 20-20)
– Bank angle sensor (page 5-73)
– ECM (page 5-75)
5-58
07ZAJ-S7C0100
3
(6.4 US oz, 6.6 Imp oz) minimum
HOSE ATTACHMENT
3P (NATURAL) CONNECTOR