Service Rules - Honda Transalp XL700V Manual

GENERAL INFORMATION

SERVICE RULES

GENERAL INFORMATION
1. Use genuine Honda or Honda-recommended parts and lubricants or their equivalents. Parts that don't meet Honda's
design specifications may cause damage to the motorcycle.
2. Use the special tools designed for this product to avoid damage and incorrect assembly.
3. Use only metric tools when servicing the motorcycle. Metric bolts, nuts and screws are not interchangeable with
English fasteners.
4. Install new gaskets, O-rings, cotter pins, and lock plates when reassembling.
5. When tightening bolts or nuts, begin with the larger diameter or inner bolt first. Then tighten to the specified torque
diagonally in incremental steps unless a particular sequence is specified.
6. Clean parts in cleaning solvent upon disassembly. Lubricate any sliding surfaces before reassembly.
7. After reassembly, check all parts for proper installation and operation.
8. Route all electrical wires as shown in the Cable and Harness Routing (page 1-21).
9. Do not bend or twist control cables. Damaged control cables will not operate smoothly and may stick or bind.
ABBREVIATION
Throughout this manual, the following abbreviations are used to identify the respective parts or systems.
Abbrev. term
ABS
CKP sensor
CMP sensor
DLC
DTC
ECM
ECT sensor
EEPROM
EOP switch
HDS
HISS
IACV
IAT sensor
MAP sensor
MIL
PAIR
PCV
PGM-FI
SCS connector
TP sensor
VS sensor
1-2
Anti-lock Brake System
Crankshaft Position sensor
Camshaft Position sensor
Data Link Connector
Diagnostic Trouble Code
Engine Control Module
Engine Coolant Temperature sensor
Electrically Erasable Programmable Read Only Memory
Engine Oil Pressure switch
Honda Diagnostic System
Honda Ignition Security System
Idle Air Control Valve
Intake Air Temperature sensor
Manifold Absolute Pressure sensor
Malfunction Indicator Lamp
Pulsed Secondary Air Injection
Proportional Control Valve
Programmed Fuel Injection
Service Check Short connector
Throttle Position sensor
Vehicle Speed sensor
Full term