Install the injector and fuel feed hose to the throttle
body, being careful not to damage the seal ring.
Install and tighten the bolts to the specified torque.
TORQUE: 5.4 N·m (0.6 kgf·m, 4.0 lbf·ft)
Connect the fuel hose quick connector (page 5-55).
Connect the injector 2P (Gray) connector.
Install the air cleaner housing (page 5-64).
MAP SENSOR
REMOVAL/INSTALLATION
Remove the wire harness cover (page 2-10).
Disconnect the MAP sensor 3P (Black) connector
and vacuum hose.
Remove the screw and MAP sensor.
Installation is in the reverse order of removal.
TORQUE:
MAP sensor mounting screw:
5.0 N·m (0.5 kgf·m, 3.7 lbf·ft)
FUEL SYSTEM (PGM-FI)
INJECTOR
FUEL FEED HOSE
QUICK CONNECTOR
2P (GRAY) CONNECTOR
SCREW
3P (BLACK) CONNECTOR
VACUUM HOSE
SEAL RING
BOLTS
INJECTOR
MAP SENSOR
5-71