Install the brake pad (page 15-17).
Install the brake hose with new sealing washers and
oil bolt.
Push the brake hose stopper on the caliper, then
tighten the oil bolt to the specified torque.
TORQUE: 34 N·m (3.5 kgf·m, 24 lbf·ft)
Fill and bleed the hydraulic system.
– XL700V (page 15-8)
– XL700VA (page 15-12)
BRAKE PEDAL
REMOVAL
Remove the rear master cylinder (page 15-34).
Remove the return spring, brake pedal pinch bolt
and spring rod.
Remove the brake pedal and dust seals.
INSTALLATION
Apply grease to the sliding surface of the brake
pedal pivot and new dust seal lips.
Install new dust seals and brake pedal to the step
holder.
HYDRAULIC BRAKE
SEALING WASHERS
SPRING ROD
DUST SEALS
DUST SEALS
OIL BOLT
RETURN SPRING
BOLT
BRAKE PEDAL
BRAKE
PEDAL
15-45