Crankshaft Removal; Crankshaft/Connecting Rod - Honda Transalp XL700V Manual

CRANKCASE/CRANKSHAFT/TRANSMISSION
Loosen the 6 mm and 8 mm bolts with washer in a
crisscross pattern in several steps, then remove
them.
Set the shift drum to the position as shown.
Place the crankcase with the left crankcase down
and remove the right crankcase.
• Separate the right crankcase from the left crank-
case while prying at the points as shown.
• Separate the right crankcase from the left crank-
case while softly tapping them at several loca-
tions with a soft hammer.
Remove the dowel pins and pipe seal.
Clean off the sealant from the left and right crank-
case mating surfaces.

CRANKSHAFT/CONNECTING ROD

CRANKSHAFT REMOVAL

Separate the crankcase (page 12-7).
Remove the crankshaft/connecting rod from the left
During crankshaft
crankcase.
and connecting rod
service, be careful
not to damage the
main journal or
crank pin bearing
inserts.
12-8
8 mm BOLTS 8 mm BOLT/WASHER
SHIFT DRUM
RIGHT CRANKCASE
PRY POSITIONS
DOWEL PINS
CRANKSHAFT/CONNECTING ROD
6 mm BOLTS
PIPE SEAL