Honda Transalp XL700V Manual page 98

Loosen the lock nut and turning the adjusting screw
until there is a slight drag on the feeler gauge.
TOOL:
Tappet adjust wrench, 4 mm
Hold the adjusting screw and tighten the lock nut to
Apply engine oil to
the specified torque.
the lock nut threads
and seating
TORQUE: 23 N·m (2.3 kgf·m, 17 lbf·ft)
surface.
After tightening the lock nut, recheck the valve
clearance.
Coat new O-rings with engine oil and install them
into the timing and crankshaft hole cap grooves.
Apply engine oil to the timing and crankshaft hole
cap threads.
Install the timing hole cap and tighten it to the spec-
ified torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
Install the crankshaft hole cap and tighten it to the
specified torque.
TORQUE: 15 N·m (1.5 kgf·m, 11 lbf·ft)
Install the cylinder head cover (page 8-33).
REAR:
Remove the cylinder head cover (page 8-6).
Remove the timing and crankshaft hole caps.
Rotate the crankshaft counterclockwise and align
the "RT" mark on the flywheel with the index notch
on the left crankcase cover.
Make sure the piston is at TDC (Top Dead Center) on
the compression stroke.
07908-KE90100
TIMING HOLE CAP
CRANKSHAFT HOLE CAP
INDEX NOTCH
"RT" MARK
MAINTENANCE
TAPPET ADJUSTING WRENCH
O-RINGS TIMING HOLE CAP
CRANKSHAFT HOLE CAP
3-11