Thermostat Housing; Radiator - Honda Transalp XL700V Manual

COOLING SYSTEM

THERMOSTAT HOUSING

REMOVAL/INSTALLATION
Remove the left air guard (page 2-10).
Drain the coolant from by removing the water pump
drain bolt (page 6-7).
Loosen the band screws and disconnect the water
hoses.
Remove the thermostat housing mounting bolt.
Disconnect the ECT sensor 3P (Gray) connector.
Remove the thermostat housing.
Install the thermostat housing assembly in the
Route the hoses
reverse order of removal.
and wires properly
(page 1-21).
Tighten the water hose band screws to the specified
range as shown.

RADIATOR

REMOVAL
Drain the coolant from by removing the water pump
Be careful not to
drain bolt (page 6-7).
damage the radiator
Lift and support the fuel tank (page 3-5).
fins while servicing
Remove the right and left air guard (page 2-10).
the radiator and fan
motor.
Loosen the band screws and disconnect the water
hoses.
Disconnect the siphon hose and joint hose.
Disconnect the fan motor 2P (Black) connector.
Remove the bolts and radiators.
6-10
WATER
HOSES
3P (GRAY) CONNECTOR
0 – 1.0 mm (0 – 0.04 in)
2P (BLACK) CONNECTOR
SIPHON HOSE
WATER HOSES
RADIATORS
BOLT
JOINT HOSE
BOLTS