Coolant Temperature Gauge; Ect Sensor - Honda Transalp XL700V Manual

LIGHTS/METERS/SWITCHES
If the value is 0 V, check for continuity between the
combination meter 20P connector and ECM 33P
(Gray) connector Yellow/green terminals.
TOOL:
Test probe
If there is no continuity, check the wire harness for
an open circuit.
If there is continuity, replace the combination meter
assembly (page 20-10).

COOLANT TEMPERATURE GAUGE/

ECT SENSOR

• Before starting the inspection, check the thermo-
stat housing mounting bolt.
If the thermostat housing mounting bolt is loose,
tighten it.
INSPECTION
If the engine coolant temperature indicates too high
or too low temperature in spite of normal engine
coolant temperature, inspect the following.
Remove the left front side cowl (page 2-9).
Disconnect the ECT sensor 3P (Gray) connector.
COOLANT TEMPERATURE GAUGE INDICATE THE
"– – –"
1. ECT Sensor Line Short Circuit Inspection
Ground the Green/blue wire of the ECT 3P (Gray)
connector with a jumper wire.
Do the temperature indicate "132 ° C" and warn-
ing indicator blinks?
YES
NO
20-14
07ZAJ-RDJA110
– Faulty ECT sensor
– GO TO STEP 2.
20P (GRAY) CONNECTOR
(Viewed from harness side)
33P (GRAY) CONNECTOR
(Wire side/female terminal)
3P (GRAY) CONNECTOR
WARNING INDICATOR
COOLANT TEMPERATURE GAUGE
Y/G