Honda Transalp XL700V Manual page 205

FUEL SYSTEM (PGM-FI)
Turn the ignition switch OFF.
Remove the headlight (page 20-6).
Remove the screws and bank angle sensor.
Do not disconnect
the bank angle
Connect the bank angle sensor 3P (Black) connector.
sensor connector
during inspection.
Place the bank angle sensor is normal position as
If you check this
shown, and ignition switch ON and engine stop
test, the ignition
switch " " then bank angle sensor is normal if the
switch "OFF", then
engine stop relay clicks and power supply is closed.
turn the ignition
switch "ON" and
Incline the bank angle sensor approximately 60° to
engine stop switch
the left or right with keep the ignition switch ON and
" ".
engine stop switch " " then bank angle sensor is
normal if the engine stop relay clicks and power
supply is open.
REMOVAL/INSTALLATION
Remove the headlight (page 20-6).
Disconnect the bank angle sensor 3P (Black) con-
nector.
Remove the screws and bank angle sensor.
Install the bank angle sensor with its "UP" mark fac-
Route the sensor
ing up.
wire properly (page
Tighten the mounting screws to the specified
1-21).
torque.
TORQUE: 1.5 N·m (0.2 kgf·m, 1.1 lbf·ft)
Connect the bank angle sensor 3P (Black) connector.
Install the headlight (page 20-6).
5-74
BANK ANGLE SENSOR
SCREWS 3P (BLACK) CONNECTOR
60° BANK ANGLE POSITION
60° (approximately)
NORMAL
POSITION
60° (approximately)
BANK ANGLE SENSOR
SCREWS 3P (BLACK) CONNECTOR