Club Car 2009-20011 Electric Precedent Maintenance And Service Manual page 380

21
Transaxle
CAUTION
• Do not position fingers under motor when sliding motor off of the input shaft. Fingers may get
pinched when motor disengages.
767
Figure 21-8 Disconnect Shocks
11. Carefully remove the motor from the transaxle. Slide the motor away from the transaxle until the motor spline
becomes disengaged from the input shaft, then lift motor out. See preceding WARNING.
12. If a floor jack was used, pull floor jack from beneath the transaxle and allow the springs to rest on the floor.
13. Remove the U-bolts attaching the transaxle to the leaf springs (Figure 21-10, Page 21-7).
14. Carefully lift each end of the transaxle off its positioning pin (on the leaf spring) and slide the transaxle to the rear
and out of the vehicle.
15. Drain the lubricant from the transaxle and remove the axle shafts. See Axle Shaft and Oil Seal Removal on
page 21-1.See following NOTE.
NOTE: Recycle or dispose of used oil or lubricant in accordance with local, state, and federal regulations.
16. Remove the brake assemblies if required. See Brake Cluster Removal on page 6-11.
Page 21-6 2009-2011 Electric Precedent Maintenance and Service Manual
768
Figure 21-9 Shackles
TRANSAXLE (TYPE G)