Club Car 2009-20011 Electric Precedent Maintenance And Service Manual page 287

IQ DISPLAY MODULE (IQDM) AND IQDM-P
DIAGNOSTICS: IQ SYSTEM
4.3.1. Disconnect the square four-pin connector (3) from the speed controller.
4.3.2. Connect the handset cord to the handset.
4.3.3. Connect the other end of the handset cord (without the adapter) (4) to the four-pin connector of the
speed controller (2) (Figure 15-8, Page 15-21).
4.3.4. Connect the vehicle batteries, positive (+) cable first.
4.3.5. If the handset functions when connected directly to the speed controller, the adapter plug or vehicle
wire harness should be thoroughly tested. See Test Procedure 2 – Handset Cord Adaptor on
page 15-19. See Section 11 – IQ System Troubleshooting – TPS.
4.4. Replace electronics module cover. See Electronics Module Cover Installation on page 17-5.
701
Figure 15-8 IQDM Connector On Speed Controller
2009-2011 Electric Precedent Maintenance and Service Manual
15
Test Procedures
Page 15-21