Electronics Module Cover; Electronics Module Cover Removal; Electronics Module Cover Installation - Club Car 2009-20011 Electric Precedent Maintenance And Service Manual

ELECTRICAL COMPONENTS

ELECTRONICS MODULE COVER

See General Warnings on page 1-1.
The electronics module cover needs to be removed to gain access to the speed controller, Tow/Run switch, and
onboard computer.

ELECTRONICS MODULE COVER REMOVAL

1. Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles
on page 1-3.
2. Remove the two plastic rivets (1) that secure the access panel (2) to the vehicle (Figure 17-5, Page 17-6).
3. Remove cover (5) by first releasing the two hooks (4) that secure the cover to the battery bucket. Then, maneuver
the cover to release the four tabs (3) from the matching holes in the hood of the battery bucket.
CAUTION
• Be careful not to break the two hooks (4) on the bottom of the cover. Push the bottom of the cover up
to release the hooks before pulling cover away from battery bucket.

ELECTRONICS MODULE COVER INSTALLATION

1. Install cover (5) by first hooking the four tabs (3) into the matching holes in the hood of the battery bucket (Figure
17-5, Page 17-6). Then, use the two hooks (4) to secure the cover to the battery bucket.
2. Place access panel (2) on vehicle and secure with the two plastic rivets (1). See following CAUTION.
CAUTION
• Exposure to water may damage electronic components.
– Do not operate vehicle without this cover properly installed.
– Do not direct water stream in the area of the cover.
3. Place the Tow/Run switch in the TOW position and connect the batteries. See Connecting the Batteries –
Electric Vehicles on page 1-3.
2009-2011 Electric Precedent Maintenance and Service Manual
Electronics Module Cover
Page 17-5
17