Brake Cable Installation - Club Car 2009-20011 Electric Precedent Maintenance And Service Manual

6
Brake Cable Removal and Installation
6
5
2
3
1
650
Figure 6-20 Loosen Brake Cables
6. Rotate the bolt (5) and equalizer bracket (4) to the upright position then slip the cable heads out of the bracket.
7. Remove nut (1) from the bolt (2) that secures front of the leaf spring (Figure 6-22, Page 6-14). Do not remove
bolt (2).
8. Remove the mounting tab (3) of the brake cable from the bolt.
9. Using brake cable release tool (P/N 102555501), compress the retaining clips (7) on the end of the cable housing
enough to slide the cable end out of the hole in the frame (Figure 6-20, Page 6-14).
10. Remove bow tie locking pin (1) and the clevis pin (2) from the brake lever on each wheel and pull the clevis
(3) away from the lever. (Figure 6-21, Page 6-14).
11. Using brake cable release tool (P/N 102555501), compress the retaining clips on the end of the cable housing
enough to slip the cable end out of the bracket (4) and remove the brake cable from the vehicle.
4
651
Figure 6-21 Disconnect Cables at Rear Brakes

BRAKE CABLE INSTALLATION

WARNING
• 2009 model year Precedent vehicles had a running change in brake cable design (Figure 6-19, Page
6-13). Never mix components of the different designs. See NOTE at beginning of this section.
Page 6-14 2009-2011 Electric Precedent Maintenance and Service Manual
7
4
2
3
1
2
652
Figure 6-22 Brake Cable Mounting Tab
WHEEL BRAKE ASSEMBLIES
3
1