Club Car 2009-20011 Electric Precedent Maintenance And Service Manual page 362

20
Motor
729
Figure 20-1 Lift Vehicle with Floor Jack
5. Remove both rear wheels.
6. Remove the nut, cup washer, and bushing from the bottom side of the shock absorber. Compress the shock
absorber (pushing upwards) to move it out of the way (Figure 20-3, Page 20-4).
7. Remove the nuts and bolts mounting the rear leaf springs to the shackles.
8. To gain easier access to the motor, lower the transaxle as low as it will go. If more room is needed, remove the
jack from beneath the transaxle and allow the springs to rest on the floor (Figure 20-3, Page 20-4).
731
Figure 20-3 Lower Axle
9. Remove the bolts and lock washers that secure the motor to the transaxle (Figure 20-24, Page 20-16). See
following CAUTION.
CAUTION
• Do not position fingers under motor when sliding motor off of the input shaft in step 9. Fingers may
get pinched when motor disengages.
10. Carefully slide the motor away from the transaxle until the motor spline disengages the input shaft and remove
the motor from the vehicle.
Page 20-4 2009-2011 Electric Precedent Maintenance and Service Manual
MOTOR (MODEL EJ4-4001 AND EJ8-4001A)
682
Figure 20-2 Vehicle Supported on Jack Stands