Pedal Group Installation; Mcor - Club Car 2009-20011 Electric Precedent Maintenance And Service Manual

5
Pedal Group – MCOR
629
Figure 5-3 Pedal Group Access
4. Remove fastener (10) and lift off cover plate (7) (Figure 5-4, Page 5-5).
5. Loosen jam nuts (4 and 5) on each side of turnbuckle (6).
NOTE: Nut (4) has a left-hand thread.
6. Loosen turnbuckle (6) until the threaded rod (8) from the pedal group (11) is free of the turnbuckle (Figure 5-4,
Page 5-5).
7. Remove two screws (2) on the driver side of the pedal group and two screws (1) on the passenger side of
the pedal group.
8. Disconnect the electrical connectors (12) at the MCOR (13).
9. Lift pedal group from vehicle.

PEDAL GROUP INSTALLATION

1. Connect the wire harness (12) to the MCOR (13) (Figure 5-4, Page 5-5).
2. Position the pedal group in vehicle and secure with two screws (2) on the driver side and two screws (1) on the
passenger side. Tighten driver side screws (2) to 97 in-lb (11 N·m). Tighten passenger side screws (1) to
18 in-lb (2 N·m).
3. Remove the turnbuckle (6) and apply Loctite 242 to the threaded ends of both the rod from the pedal group (8)
and the brake actuator rod (9). Connect the rods using the turnbuckle (6). Ensure the ends of the brake cables do
not slip out of the brake equalizer during this procedure.
4. Adjust the brake cable equalizer tension. See Brake Cable Equalizer Adjustment on page 6-10.
5. Place floor cover plate (7) over the floor opening and secure with fastener (10) (Figure 5-2, Page 5-2).
6. Install the floor mat (2) over the pedal group. Make sure tabs on floor mat sides are beneath the sill (3). Tighten
screws (1) to 53 in-lb (6 N·m) (Figure 5-1, Page 5-1).

MCOR

The pedal group for the Precedent electric vehicle includes a Motor Controller Output Regulator (MCOR) mounted on
the side of the pedal group. The MCOR detects the position of the GO pedal and sends a corresponding voltage to
the motor controller.
Page 5-4 2009-2011 Electric Precedent Maintenance and Service Manual
ACCELERATOR AND BRAKE PEDAL GROUP