ELECTRICAL COMPONENTS
3.
Disconnect the 18-gauge pink and orange/white wires from reverse buzzer.
4.
Remove the two screws from the reverse buzzer. Remove the reverse buzzer from the dash panel.
REVERSE BUZZER INSTALLATION
1.
Install the reverse buzzer in the reverse order of removal. Pink wire must be connected to the positive terminal.
Tighten screws to 4 in-lb (0.45 N·m).
2.
Place the Tow/Run switch in the TOW position and connect the batteries. See Connecting the Batteries –
Electric Vehicles on page 1-3.
1
(Viewed from underside of instrument panel)
A. Pink B. Orange/White
711
Figure 17-7 Reverse Buzzer
ELECTRONICS MODULE
See General Warnings on page 1-1.
While it is not necessary to remove the electronics module from the vehicle, access to individual components may be
easier with the module removed.
ELECTRONICS MODULE REMOVAL
1.
Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles
on page 1-3.
2.
Remove the batteries from the vehicle to provide enough room to access the controller (8) (Figure 17-8, Page
17-11). See Battery Replacement on page 18-15.
3.
Remove the bolt (11) that secures the electronics module to the battery bucket.
4.
Pull electronics module forward and disconnect the heavy gauge wires from the controller by removing the
three screws (9).
4
2009-2011 Electric Precedent Maintenance and Service Manual
17
Electronics Module
Page 17-9