Club Car 2009-20011 Electric Precedent Maintenance And Service Manual page 310

16
Test Procedures
4.3.1. Disconnect the square four-pin connector (3) from the speed controller.
4.3.2. Connect the handset cord to the handset.
4.3.3. Connect the other end of the handset cord (without the adapter) (4) to the four-pin connector of the
speed controller (2) (Figure 16-9, Page 16-22).
4.3.4. Connect the vehicle batteries, positive (+) cable first.
4.3.5. If the handset functions when connected directly to the speed controller, the adapter plug or vehicle
wire harness should be thoroughly tested. See Test Procedure 2 – Handset Cord Adaptor on
page 16-20. See Section 13 – Excel System Troubleshooting – TPS.
4.4. Replace electronics module cover. See Electronics Module Cover on page 17-5.
701
Figure 16-9 IQDM Connector On Speed Controller
Page 16-22 2009-2011 Electric Precedent Maintenance and Service Manual
IQ DISPLAY MODULE (IQDM) AND IQDM-P
DIAGNOSTICS: EXCEL SYSTEM