MOTOR (MODEL EJ4-4001 AND EJ8-4001A)
752
Figure 20-8 Armature Removal
754
Figure 20-10 Brush Rigging
MOTOR COMPONENT TESTING AND INSPECTION
See General Warnings on page 1-1.
ARMATURE INSPECTION AND TESTING
1.
Remove the motor from the vehicle. See Motor Removal on page 20-3.
2.
Remove the end cap and armature by performing steps 1 through 7 of Motor Disassembly on page 20-5.
Visual Inspection
• Burned, charred or cracked insulation
• Improperly cured varnish
• Thrown solder
753
755
2009-2011 Electric Precedent Maintenance and Service Manual
Motor Component Testing and Inspection
Figure 20-9 A1 and A2 Terminals
Figure 20-11 Bearing Retaining Ring
20
Page 20-7