Throttle Position Sensor (Tps); Pedal Group Installation; Pedal Group - Mcor; Pedal Group Removal - Club Car 2009-20011 Electric Precedent Maintenance And Service Manual

ACCELERATOR AND BRAKE PEDAL GROUP

THROTTLE POSITION SENSOR (TPS)

The pedal group for the Precedent electric vehicle includes a throttle position sensor mounted on the side of the
accelerator pedal assembly. The throttle position sensor detects the position of the accelerator pedal and sends a
corresponding voltage to the motor controller. The throttle position sensor itself is not intended to be replaced. If sensor
is determined to need replacing through test procedures found in this manual, the accelerator pedal assembly must be
replaced. See Accelerator Pedal Removal on page 5-6.

PEDAL GROUP INSTALLATION

1. Connect the wire harness (12) to the throttle position sensor (Figure 5-2, Page 5-2).
2. Position the pedal group in vehicle and secure with two screws (2) on the driver side and two screws (1) on the
passenger side. Tighten driver side screws (2) to 97 in-lb (11 N·m). Tighten passenger side screws (1) to
18 in-lb (2 N·m).
3. Remove the turnbuckle (6) and apply Loctite 242 to the threaded ends of both the rod from the pedal group (8)
and the brake actuator rod (9). Connect the rods using the turnbuckle (6). Ensure the ends of the brake cables do
not slip out of the brake equalizer during this procedure.
4. Adjust the brake cable equalizer tension. See Brake Cable Equalizer Adjustment on page 6-10.
5. Place floor cover plate (7) over the floor opening and secure with fastener (10) (Figure 5-2, Page 5-2).
6. Install the floor mat (2) over the pedal group. Make sure tabs on floor mat sides are beneath the sill (3). Tighten
screws (1) to 53 in-lb (6 N·m) (Figure 5-1, Page 5-1).
PEDAL GROUP – MCOR
See General Warnings on page 1-1.

PEDAL GROUP REMOVAL

1. Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles
on page 1-3.
2. Remove screws (1). Pull floor mat retainer (3) away from the vehicle (Figure 5-3, Page 5-4).
3. Pull floor mat (2) over the pedal group to gain access to the pedal group hardware.
2009-2011 Electric Precedent Maintenance and Service Manual
Pedal Group – MCOR
Page 5-3
5