17
Battery Warning Light
3.2. Position the instrument panel (2) on the dash assembly. Make sure tabs on upper edge properly engage
with the corresponding slots on the dash assembly. Ensure that there are no wires exposed or pinched
during positioning.
3.3. Secure instrument panel to the dash assembly with three screws (1). Tighten screws to 1.8 ft-lb (2.5 N·m).
4.
Connect the batteries. See Connecting the Batteries – Electric Vehicles on page 1-3.
702
Figure 17-1 Instrument Panel Removal
BATTERY WARNING LIGHT
See General Warnings on page 1-1.
TESTING THE BATTERY WARNING LIGHT
See Test Procedure 26 – Battery Warning Light on page 12-38 or 14-37.
BATTERY WARNING LIGHT REMOVAL
1.
Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles
on page 1-3.
2.
Remove instrument panel. See Key Switch Removal on page 17-1.
3.
Disconnect the wires at the warning light.
4.
Press the two retaining tabs (11) and remove the light from the center dash (Figure 17-3, Page 17-3).
Page 17-2
2009-2011 Electric Precedent Maintenance and Service Manual
1
3
1
9
703
Figure 17-2 Key Switch
ELECTRICAL COMPONENTS
8
6