Club Car 2009-20011 Electric Precedent Maintenance And Service Manual page 166

12
Test Procedures
TEST PROCEDURE 7 – Battery Pack Voltage (Under Load)
See General Warnings on page 1-1.
1. Be sure the batteries are fully charged and that the electrolyte level is correct in all cells.
2. Connect the tester leads to the positive (+) post of battery no.1 and negative (–) post of battery no. 4 (Figure
12-11, Page 12-20 and Figure 12-12, Page 12-20) or battery no. 6 (Figure 12-13, Page 12-20).
1
(Viewed from driver side of vehicle)
1. RED probe to battery no. 1 (+).
2. BLACK probe to battery no. 4 (-).
2500-30100-10409
Figure 12-11 Battery Discharge Test – Style A Battery
Configuration
(+)
1
2
3
(Viewed from driver side of vehicle)
1. RED probe to battery no. 1 (+).
2. BLACK probe to battery no. 4 (-).
2500-30100-10410
Figure 12-12 Battery Discharge Test – Style B Battery
Configuration
3. Turn the discharge machine on and record the voltage reading of battery pack while under load.
4. A fully charged set of batteries in good condition should read between 46-49 volts while under load.
Page 12-20 2009-2011 Electric Precedent Maintenance and Service Manual
4
IQ SYSTEM TROUBLESHOOTING – MCOR
1
(Viewed from driver side of vehicle)
1. RED probe to battery no. 1 (+).
2. BLACK probe to battery no. 6 (-).
2500-30100-10411
Figure 12-13 Battery Discharge Test – Style C Battery
Configuration