Club Car 2009-20011 Electric Precedent Maintenance And Service Manual page 218

Iq system and excel system vehicles
Table of Contents

Advertisement

13
Test Procedures
– Black wire terminal socket in the charger receptacle.
– Onboard computer gray wire. See Test Procedure 19 – Onboard Computer Gray Wire on page 13-30.
– Red wire at the charger receptacle. See Test Procedure 20 – Voltage at Charger Receptacle Red Wire
Socket on page 13-30.
TEST PROCEDURE 19 – Onboard Computer Gray Wire
See General Warnings on page 1-1.
1.
With batteries connected and the DC cord disconnected, pull back on the boot (1) on the gray wire (2) connection
at the OBC (3) (Figure 13-18, Page 13-30). Using a multimeter set to 200 volts DC, connect the red (+) probe to
the positive post of battery no. 1 and black (–) probe to gray 16-gauge wire at the OBC connection (4). Reading
should be approximately 48 volts. If reading is zero volts, replace the OBC.
693
Figure 13-18 OBC Connections
2.
If the reading in step 1 is 48 volts, plug the DC cord into the vehicle's charger receptacle. The voltage reading
should drop to approximately 4.0 volts before the charger relay clicks on.
3.
When the charger relay is activated, the reading should rise to approximately 48 volts.
4.
If voltage does not drop to approximately 4.0 volts when the DC cord is plugged in and then rise to approximately
48 volts when the charger relay clicks on, the gray wire circuit in the OBC has failed. Replace the OBC.
TEST PROCEDURE 20 – Voltage at Charger Receptacle Red Wire Socket
See General Warnings on page 1-1.
1.
With batteries connected, DC cord disconnected, and using a multimeter set to 200 volts DC, place the black
(–) probe on the negative post of battery no. 4 (4 x 12-Volt battery set) or battery no. 6 (6 x 8-Volt battery set)
and place the red (+) probe on the charger receptacle socket connected to the red 10-gauge wire. The reading
should be 48-50 volts (full battery voltage).
2.
If the reading is zero volts, check the continuity of the 10-gauge red wire from the positive post of battery no. 1
to the receptacle socket.
Page 13-30
2009-2011 Electric Precedent Maintenance and Service Manual
4
1
2
3
EXCEL SYSTEM TROUBLESHOOTING – TPS

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents