Battery Warning Light Installation; Forward/Reverse Rocker Switch; Testing The Forward/Reverse Rocker Switch; Forward/Reverse Rocker Switch Removal - Club Car 2009-20011 Electric Precedent Maintenance And Service Manual

ELECTRICAL COMPONENTS

BATTERY WARNING LIGHT INSTALLATION

1. Install in reverse order of removal.
2. Place the Tow/Run switch in the TOW position and connect the batteries. See Connecting the Batteries –
Electric Vehicles on page 1-3.
704
Figure 17-3 Battery Warning Light

FORWARD/REVERSE ROCKER SWITCH

See General Warnings on page 1-1.

TESTING THE FORWARD/REVERSE ROCKER SWITCH

See Test Procedure 23 – Forward/Reverse Rocker Switch on page 12-35 or 14-35.

FORWARD/REVERSE ROCKER SWITCH REMOVAL

1. Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles
on page 1-3.
2. Remove two screws (2) that hold Forward/Reverse rocker switch housing (1) to the vehicle (Figure 17-4, Page
17-4).
3. Remove the three wires from the rocker switch.
4. Press in on the locking tabs on each side of switch (3), and push switch out of housing.
11
2009-2011 Electric Precedent Maintenance and Service Manual
Forward/Reverse Rocker Switch
17
Page 17-3