Canopy - Two-Passenger; Two-Passenger Canopy Removal - Club Car 2009-20011 Electric Precedent Maintenance And Service Manual

4
Canopy – Two-Passenger
2. Lift the rear edge of the rear underbody (4) until the front portion slides out from beneath the front underbody.
Remove the rear underbody from the vehicle.
Rear Underbody Installation
Install rear underbody (4) on the vehicle (Figure 4-8, Page 4-12). Install four screws (5) to secure the underbody to its
vehicle. Tighten screws (5 and 18) to 3.7 ft-lb (5 N·m).
CANOPY – TWO-PASSENGER
See General Warnings on page 1-1.
CAUTION
• To prevent damage to the canopy, do not remove the canopy supports (3, 7, and 10) from the vehicle
without first removing the canopy (1) (Figure 4-12, Page 4-17).

TWO-PASSENGER CANOPY REMOVAL

1. Remove the two nuts (9) and two bolts (8) from the canopy (1) and each front canopy support (7 and 10) (Figure
4-12, Page 4-17).
2. Remove the nuts (5) and bolts (4) from the canopy (1) and each rear support (3).
3. Lift canopy (1) away from front canopy supports (7 and 10) and rear supports (3).
4. Remove screws (14) securing front canopy support covers to front body.
5. Slide canopy support covers (12 and 13) up front canopy supports (7 and 10) to gain access to bolts (11).
6. Remove two bolts (11) from each front canopy support (7 and 10) and remove canopy supports from the vehicle.
7. Remove bolt (6) from each rear support (3) and pull rear supports from vehicle.
Page 4-16 2009-2011 Electric Precedent Maintenance and Service Manual
BODY AND TRIM