Canopy (Monsoon Version) - Four-Passenger; Monsoon Canopy Removal; Monsoon Canopy Installation - Club Car 2009-20011 Electric Precedent Maintenance And Service Manual

BODY AND TRIM
CANOPY (MONSOON VERSION) – FOUR-PASSENGER
See General Warnings on page 1-1.
CAUTION
• To prevent damage to the canopy, do not remove the canopy supports (1, 2, 8 and 9) from the vehicle
without first removing the canopy (13) (Figure 4-16, Page 4-24).

MONSOON CANOPY REMOVAL

1. Remove the two nuts (17), two washers (16), and two bolts (15) from the canopy (13) at each front canopy
support (8 and 9) (Figure 4-16, Page 4-24).
2. Remove the four bolts (18) from the canopy (13) at each rear support (1 and 2).
3. Lift canopy (13) off the canopy supports.
4. Remove screws (12) securing front canopy support covers (11) to front body.
5. Slide canopy support covers (11) up front canopy supports (8 and 9) to gain access to bolts (10).
6. Remove two bolts (10) from each front canopy support (8 and 9) and remove the canopy supports from the vehicle.
7. Remove the four nuts (7), eight washers (6), and four bolts (5) securing each rear canopy support (1 and 2) and
remove the canopy supports from the vehicle (Figure 4-14, Page 4-22).

MONSOON CANOPY INSTALLATION

1. Secure the rear canopy supports.
1.1. Position each rear canopy support (1 and 2) to the side of the seat support assembly (3) as shown (Figure
4-14). Make sure the bottom of the strut is in the hole (4) in the rear body to allow for water drainage.
1.2. Secure each rear canopy support (1 and 2) to the seat support assembly with four 1/4-20 x 1- hex head bolts
(5), eight 1/4-inch flat washers (6) and four 1/4-20 nylon lock nuts (7). Tighten hardware to 80 in-lb (9 N·m).
2009-2011 Electric Precedent Maintenance and Service Manual
Canopy (Monsoon Version) – Four-Passenger
4
Page 4-21