SECTION 5 – ACCELERATOR AND BRAKE PEDAL GROUP
DANGER
• See General Warnings on page 1-1.
WARNING
• See General Warnings on page 1-1.
PEDAL GROUP – THROTTLE POSITION SENSOR
See General Warnings on page 1-1.
PEDAL GROUP REMOVAL
1.
Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles
on page 1-3.
2.
Remove screws (1). Pull floor mat retainer (3) away from the vehicle (Figure 5-1, Page 5-1).
3.
Pull floor mat (2) over the pedal group to gain access to the pedal group hardware.
4.
Remove fastener (10) and lift off cover plate (7) (Figure 5-2, Page 5-2).
5.
Loosen jam nuts (4 and 5) on each side of turnbuckle (6).
NOTE: Nut (4) has a left-hand thread.
6.
Loosen turnbuckle (6) until the threaded rod (8) from the pedal group (11) is free of the turnbuckle (Figure 5-2,
Page 5-2).
629
Figure 5-1 Pedal Group Access
2009-2011 Electric Precedent Maintenance and Service Manual
5
Page 5-1