Club Car 2009-20011 Electric Precedent Maintenance And Service Manual page 183

IQ SYSTEM TROUBLESHOOTING – MCOR
7. Place the Forward/Reverse switch in REVERSE. Using a multimeter set to 200 volts DC, place the black (–)
probe on the orange/white wire terminal end (that was disconnected from the reverse buzzer) and place the red
(+) probe on battery no. 1 positive post. The reading should be approximately 48 volts (full battery voltage).
7.1. If the voltage reading is correct, replace the reverse buzzer.
7.2. If reading is zero volts, check orange/white wire continuity and connection at Pin 7 in 16-Pin connector.
7.3. If there is no continuity in the orange/white wire, or the Pin 7 terminal in the 16-Pin connector is not properly
seated, repair or replace as required.
7.4. If the orange/white wire continuity and 16-Pin connector are correct and there is no voltage at the orange
wire, replace the controller.
TEST PROCEDURE 25 – Rebooting the Onboard Computer
See General Warnings on page 1-1.
It is possible the onboard computer (OBC) can become "locked up", causing the OBC solenoid lockout circuit to
malfunction. If this condition is suspected, restart the computer as follows:
1. Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles
on page 1-3.
NOTE: Wait at least 90 seconds for the capacitors in the speed controller to discharge. The capacitors in the speed
controller must be fully discharged in order to reboot the OBC.
2. Place the Tow/Run switch in the TOW position and connect the batteries. See Connecting the Batteries –
Electric Vehicles on page 1-3.
3. Place Tow/Run switch in the RUN position.
4. Test drive the vehicle. If the vehicle functions normally the problem is corrected. If the problem still exists,
refer to Wiring Diagrams on page 12-2.
2009-2011 Electric Precedent Maintenance and Service Manual
12
Test Procedures
Page 12-37