Club Car 2009-20011 Electric Precedent Maintenance And Service Manual page 136

11
Test Procedures
200 DCV Setting (reading with Tow/Run switch in RUN and key switch in the ON position)
691
8. With the key switch in the ON position, the multimeter should indicate full battery voltage (approximately 48 volts).
With the key switch in the OFF position, the reading should be zero volts.
9. If any other reading is obtained, check the following items:
– Continuity of the wires in the wire harness
– Tow/Run switch for proper operation. See Test Procedure 6 – Tow/Run Switch on page 11-18.
– Key switch for proper operation. See Test Procedure 8 – Key Switch and Throttle Position Sensor Limit
Switch Circuit on page 11-20.
TEST PROCEDURE 17 – Pin 12
See General Warnings on page 1-1.
Pin 12 in the 16-pin connector provides a connection point for the solenoid coil to the speed controller. The speed
controller activates the solenoid coil by providing a ground to the solenoid coil at the appropriate time.
1. Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles
on page 1-3.
2. Place chocks at the front wheels and lift the rear of the vehicle with a chain hoist or floor jack. Position jack
stands under the frame rails just forward of each spring mount. See WARNING "Lift only one end..." in
General Warnings on page 1-1.
3. Disconnect the 16-pin connector at the speed controller.
4. Place a jumper wire with an alligator clip between the B– terminal of the speed controller (use alligator clip for this
connection) and pin 12 (blue/white wire) of the 16-pin connector (Figure 11-17, Page 11-29). See following
CAUTION.
CAUTION
• Do not fully insert probes into the 16-pin plug. Doing so can result in a poor connection.
5. Place the Tow/Run switch in the TOW position and connect the batteries. See Connecting the Batteries –
Electric Vehicles on page 1-3.
6. Place the Tow/Run switch in the RUN position and the key switch in the ON position.
Page 11-28 2009-2011 Electric Precedent Maintenance and Service Manual
Figure 11-16 Pin 10 Test
IQ SYSTEM TROUBLESHOOTING – TPS
WAVETEK
V
OFF
1000
200
20
2
200
m
2000
k
200k
20k
2k
! COM
V
MAX
1000 ---
750V
5XL
V
500
200
200
2m
20
m
200
m
200
A
! 200nA
FUSED