Charger Receptacle Installation; Headlight Adjustment; Aiming The Headlight Beam - Club Car 2009-20011 Electric Precedent Maintenance And Service Manual

17

Headlight Adjustment

5. Disconnect the gray wire from the OBC.
6. Remove the three screws (1) that secure the charger receptacle (2) to the bucket.

CHARGER RECEPTACLE INSTALLATION

1. Insert the wires through the hole in the bucket (Figure 17-9, Page 17-15).
2. Insert receptacle (2) into bucket.
3. Install the three screws (1) that secure the receptacle to the bucket. Tighten screws to 16 in-lb (1.8 N·m).
4. Connect gray wire to the OBC. Make sure boot is properly seated.
5. Connect the black wire to the mating connector. Make sure connector is fully seated.
6. Connect the red wire to the positive post of battery no. 1.
7. Install kick plate. See Kick Plate and Charger Receptacle Bezel on page 4-8.
8. Place the Tow/Run switch in the TOW position and connect the batteries. See Connecting the Batteries –
Electric Vehicles on page 1-3.
HEADLIGHT ADJUSTMENT
Headlights are available as an accessory on this vehicle. To raise or lower the headlight beam, washers can be added
to the mounting hardware between the headlight and the bumper assembly.
See General Warnings on page 1-1.

AIMING THE HEADLIGHT BEAM

1. Park the vehicle on a level surface 5 feet away from, and facing a vertical surface such as a garage door or wall.
2. On the vertical surface, mark a 24 inch long, horizontal line 15 1/2 inches above the ground directly in front of
the vehicle.
3. Turn on headlight. Take note where the beam strikes the vertical surface in relation to the marked horizontal
line. To raise the beam, add washers (size M6) to the lower mounting screw (1). To lower the beam, add
washers to both upper screws. Tighten screws to 66 in-lb (7.5 N·m). While it is possible to add washers with
the headlight/bumper assembly mounted to the vehicle, these adjustments may be easier if the headlight/front
bumper assembly is unbolted first (Figure 17-10, Page 17-17).
Page 17-16 2009-2011 Electric Precedent Maintenance and Service Manual
ELECTRICAL COMPONENTS