Forward/Reverse Rocker Switch Installation - Club Car 2009-20011 Electric Precedent Maintenance And Service Manual

17
Forward/Reverse Rocker Switch
1
705
Figure 17-4 Forward/Reverse Rocker Switch

FORWARD/REVERSE ROCKER SWITCH INSTALLATION

1. Route the three wires through bezel. Connect the blue (4), orange (5) and brown (6) wires to the rocker switch
(3), exactly as shown in (Figure 17-4, Page 17-4).
2. Orient the rocker switch (3) so the terminals are towards the front of the housing (1). Push rocker switch (3)
into housing (1).
3. Place the housing in position on the body and install the two screws (2). Tighten to 20 in-lb (2.3 N·m).
4. Place the Tow/Run switch in the TOW position and connect the batteries. See Connecting the Batteries –
Electric Vehicles on page 1-3.
5. Place the Tow/Run switch in the RUN position.
6. Inspect the vehicle for proper operation.
WARNING
• Make sure that the vehicle operates in the forward direction when the Forward/Reverse switch is
in the FORWARD position.
• Make sure that the vehicle operates in the reverse direction when the Forward/Reverse switch is in the
REVERSE position. The reverse buzzer will sound as a warning when the Forward/Reverse switch
is in REVERSE.
• Make sure that the vehicle does not operate when the Forward/Reverse switch is in the NEUTRAL
position.
Page 17-4 2009-2011 Electric Precedent Maintenance and Service Manual
3
4
5
6
ELECTRICAL COMPONENTS