Assigning A Distinctive Ring Pattern To A Hunt Group - Nortel Norstar System Administration Manual

Assigning a distinctive ring pattern to a Hunt Group

P0607114 Issue 01
9. Press '. The display shows Line assignment.
10. Press ≠. The display shows Show line:.
11. Enter the line number you want to program, press SCAN to go
the first line assigned to this group or press LIST to go to the
first line in the system.
12. Press CHANGE to programme the line as Unassigned or
Assigned.
*HGnn* means the line is assigned to another hunt group.
13. Press ® to exit or 'to continue programming.
You can assign distinctive ring patterns to your Hunt Group so
that calls can be rated in priority for the group.
These distinctive ring patterns, have the same characteristics as
for line and set distinctive ring patterns. Refer to 'Sorting calls by
distinctive ring patterns' on page 234.
The Hunt Group distinctive ring pattern determines how a call
will ring within the Hunt Group.
• If the Hunt Group ring pattern priority is higher than the line
ring pattern or the ring patterns on member telephones, the call
will ring at all telephones with the ring pattern specified for the
Hunt Group.
• If members of the group have ring patterns assigned to their
telephones that are higher than the ring patterns of the
incoming line or the Hunt Group, then the Hunt Group will use
the ring of the corresponding member telephones.
• If the incoming call (line) has a higher ring pattern assigned,
than the Hunt Group, the Hunt Group will ring with the line
ring pattern.
1. Place the programming overlay over the appropriate keys on
your programming telephone.
2. Press ≤••¤flfl‹›› (CONFIG). The display
shows Password:.
3. Press ¤flfl‹›› (CONFIG). The display shows
Terminals&Extns.
4. Press ' until the display shows System prgrming.
5. Press ≠. The display shows Hunt groups.
6. Press ≠ until the display shows Member extns:.
7. Press ' until the display shows Dstnct Ring:NONE.
8. Press CHANGE to toggle to the ring pattern number you want
to assign to the Hunt group line.
9. Press ® to exit or 'to continue programming.
Programming Hunt groups 123
Compact Plus System Administration Guide