Locking An Extension - Nortel Norstar System Administration Manual

Locking an extension

P0607114 Issue 01
You can limit the number of features that can be used or
programmed at a particular extension by determining a lock
condition for the extension.
The options are:
• None (default)— not locked. You can programme any system
or extension setting.
• Full—fully locked. You can programme only these settings:
display contrast, ring type, ring volume, and volume control.
• Partial—partly locked. You can programme most extension
settings. You cannot programme system settings, personal
speed dial codes, dialling mode, or memory keys; and you
cannot move line keys or enable Voice Call Deny.
Note: Do not apply extension lock to the extension you use to
programme the system. There must be at least one two-line
display telephone in the system that has extension lock set
to None, or you will not be able to programme the system.
1. Place the programming overlay over the appropriate keys on
your programming telephone.
2. Press ≤••¤flfl‹›› (CONFIG). The
display shows Password:.
3. Press ‡¤‡fi°‡ (SAPLUS). The display shows
Terminals&Extns.
4. Press ≠. The display shows Show extn#:.
5. Enter the extension number of the telephone you want to
programme. The displays shows nnn:nnn.
6. Press ≠. The display shows Line access.
7. Press ' until the display shows Restrictions.
8. Press ≠. The display shows Restrn filters.
9. Press '. The display shows Extn restrns.
10. Press ≠. The display shows Filters.
11. Press '. The display shows ExtnLock:.
12. Press CHANGE to select None, Full, or Partial.
13. Press ® to exit or ' to continue programming.
Barring calls and privileges (Restrictions) 93
Compact Plus System Administration Guide