Beginning A Maintenance Session - Nortel Norstar System Administration Manual

200 Maintenance

Beginning a Maintenance session

Maintenance overview
Compact Plus System Administration Guide
A Maintenance session helps you diagnose problems that may
occasionally arise within the Compact Plus system.
The Maintenance section of programming has four headings
available for System Administrator programming.
System version
Clear lines
Sys admin log
Remote montr
You can run a Maintenance session from any working T7316,
T7316E, M7310N or M7324N telephone. Only one person at a
time can access a Maintenance session. Photocopy the System
Administration Log found at the end of this chapter, and use it to
record maintenance information.
Follow these steps any time you enter a Maintenance session:
1. Release all calls on your telephone.
2. Place the programming overlay over the appropriate keys on
your programming telephone.
3. Press ≤••¤flfl‹›› (CONFIG). The
display shows Password:.
4. Press ‡¤‡fi°‡ (SAPLUS). The display shows
Terminals&Extns.
5. Press ' until the display shows Maintenance.
When necessary, refer back to these five steps on how to begin a
Maintenance programming session. Only one person at a time
can access a Maintenance session.
Displays the version number of the System
Processor software.
Clears a hung line. See "Clearing a hung
line" on page 205
Displays a list of system initialisations,
programming sessions, invalid password
attempts, and password changes.
Allows a technical specialist from a remote
location to monitor the Norstar system. It is
not a regular part of system installation or
maintenance.
P0607114 Issue 01