Changing The Dial Mode Of An Ata Or An I-Ata - Nortel Norstar System Administration Manual

Changing the dial mode of an ATA or an I-ATA

P0607114 Issue 01
4. Press ≠. The display show Show extn#:.
5. Enter the extension number of the telephone you wish to
programme. The display shows nnn:nnn.
6. Press ≠. The display shows Line access.
7. Press '. The display shows Capabilities.
8. Press ≠. The display shows Fwd no answer.
9. Press ' until the display shows ATA settings.
10. Press ≠. The display shows ATA ans timer:.
11. Press CHANGE to choose 3, 5, 7, or 10 seconds.
12. Press ® to exit or ' to continue programming.
You must tell the system whether the device connected to the
ATA sends out pulse or Dual Tone Multifrequency (DTMF)
signals.
The default signal is tone.
1. Place the programming overlay over the appropriate keys on
your programming telephone.
2. Press ≤••¤flfl‹›› (CONFIG). The
display shows Password:.
3. Press ‡¤‡fi°‡ (SAPLUS). The display shows
Terminals&Extns.
4. Press ≠. The display show Show extn#:.
5. Enter the extension number of the telephone you wish to
programme.
6. Press ≠. The display shows Line access.
7. Press '. The display shows Capabilities.
8. Press ≠. The display shows Fwd no answer.
9. Press ' until the display shows ATA settings.
10. Press ≠. The display shows ATA ans timer:.
11. Press '. The display shows ATA mode:.
12. Press CHANGE to choose Tone or Pulse.
13. Press ® to exit or ' to continue programming.
Settings for analogue equipment 153
Compact Plus System Administration Guide