40 Programming Terminals and Extensions
Terminals and extensions
Assigning a line to an extension (line access)
Line Assignment
Compact Plus System Administration Guide
Terminals&Extns allows you to assign settings to each telephone.
1. Place the programming overlay over the appropriate keys on
your programming telephone.
2. Press ≤••¤flfl‹›› (CONFIG). The
display shows Password :.
3. Press ‡¤‡fi°‡ (SAPLUS). The display shows
Terminals&Extns.
4. Press ≠. The display shows Show extn#:.
5. Enter the extension number of the telephone you want to
programme. The display shows nnn:nnn (nnn represents the
three-digit extension number).
Line access allows you to assign lines to individual extensions.
When you are finished programming line access settings for one
extension, you can copy those settings to other extensions by
using COPY at the Line Access display. For more information
about copying extension programming, see "Copying
programming for telephones" on page 147.
This setting allows you to assign physical lines and Direct Inward
Access (DIA) lines to each extension. DIA lines are assigned and
removed in the same manner as other lines.
1. Place the programming overlay over the appropriate keys on
your programming telephone.
2. Press ≤••¤flfl‹›› (CONFIG). The
display shows Password :.
3. Press ‡¤‡fi°‡ (SAPLUS). The display shows
Terminals&Extns.
4. Press ≠. The display shows Show extn#:.
5. Enter the extension number of the telephone you want to
programme. The display shows nnn:nnn.
6. Press ≠ three times. The display shows Show line:.
7. Enter the line number. The display shows Lnnn:Unassigned.
8. Press SCAN to see the setting and then press SCAN again to
view the lines assigned to this extension.
9. Press CHANGE to change the setting for each line: Appr&Ring,
Appr only, Unassigned, or Ring only.
P0607114 Issue 01