Setting Whether The Ata/I-Ata Should Receive System Tones - Nortel Norstar System Administration Manual

154 Settings for analogue equipment
Setting whether the ATA/I-ATA should receive system
tones
Compact Plus System Administration Guide
You must tell the system whether the device connected to the
ATA should receive confirmation and error tones. These tones
inform a person of call progress, but confuse a modem or fax
machine.
• If the ATA is connected to a telephone, set tones to Y.
• If the ATA is connected to any other device, set tones to N.
The default is No.
Note: This setting does not interfere with intrusion and
conference tones on a telephone connected to an ATA.
These tones are heard through the telephone handset
regardless of the ATA tones setting.
1. Place the programming overlay over the appropriate keys on
your programming telephone.
2. Press ≤••¤flfl‹›› (CONFIG). The
display shows Password:.
3. Press ‡¤‡fi°‡ (SAPLUS). The display shows
Terminals&Extns.
4. Press ≠. The display show Show extn#:.
5. Enter the extension number of the telephone you want to
programme. The display shows nnn:nnn.
6. Press ≠. The display shows Line access.
7. Press '. The display shows Capabilities.
8. Press ≠. The display shows Fwd no answer.
9. Press ' until the display shows ATA settings.
10. Press ≠. The display shows ATA ans timer:.
11. Press ' until the display shows ATA tones:.
12. Press CHANGE to choose Y (Yes) or N (No).
13. Press ® to exit or ' to continue programming.
P0607114 Issue 01