Alarm Extension - Nortel Norstar System Administration Manual

Alarm extension

P0607114 Issue 01
1. Place the programming overlay over the appropriate keys on
your programming telephone.
2. Press ≤••¤flfl‹›› (CONFIG). The
display shows Password:.
3. Press ‡¤‡fi°‡ (SAPLUS). The display shows
Terminals&Extns.
4. Press ' until the display shows System prgrming.
5. Press ≠. The display shows Hunt groups.
6. Press ' until the display shows Featr settings.
7. Press ≠. The display shows Backgrnd music.
8. Press ' until the display shows Call log space.
9. Press ≠. The display shows Reset all logs?.
10. Press YES and use the key pad to enter the space allocation for
the call log at each extension. You must use a three-digit
number (for example, 020 to give each extension 20 spaces).
11. Press YES to accept the settings and end programming. The
system automatically reallocates log space. Press NO to reset
the number of spaces allocated to each log.
An Alarm telephone displays system alarm codes, should they
occur. You can determine which telephone receives the alarms.
The default is extension 221.
The Alarm telephone must have a two-
line display.
The Alarm telephone must be an M7310N
or M7324N telephone.
See 'Recording and reporting alarm codes' on page 204 for
information on the alarm codes.
1. Place the programming overlay over the appropriate keys on
your programming telephone.
2. Press ≤••¤flfl‹›› (CONFIG). The
display shows Password:.
3. Press ‡¤‡fi°‡ (SAPLUS). The display shows
Terminals&Extns.
4. Press ' until the display shows System prgrming.
5. Press ≠. The display shows Hunt groups.
6. Press ' until the display shows Featr settings.
Programming feature settings 141
Compact Plus System Administration Guide