Assigning A Remote Access Filter - Nortel Norstar System Administration Manual

Assigning a remote access filter

P0607114 Issue 01
10. Press CHANGE.
11. Enter the number of the remote package that applies with this
COS password.
12. Press ® to exit or ' to continue programming.
People on other systems in your private network can dial into
your system over AC15A private circuits or exchange lines and
make outgoing calls from your system. Therefore, you may want
to limit the numbers that can be dialled over AC15A private
circuits and exchange lines. You do this by assigning a remote
access filter to the AC15A private circuits or exchange lines.
See 'Chart 7: Remote Access Packages' on page 320 in Appendix
A for a programming overview.
1. Place the programming overlay over the appropriate keys on
your programming telephone.
2. Press ≤••¤flfl‹›› (CONFIG). The
display shows Password:.
3. Press ‡¤‡fi°‡ (SAPLUS). The display shows
Terminals&Extns.
4. Press ' until the display shows System prgrming.
5. Press ≠. The display shows Hunt groups.
6. Press ' until the display shows Remote access.
7. Press ≠ twice. The display shows Show pkg:.
8. Enter a package number.
9. Press ≠. The display shows LinePool access.
10. Press ≠. The display shows Pool A:.
11. Press CHANGE to choose Y (Yes) or N (No).
12. Press –.
13. Press '. The display shows Remote page:.
14. Press CHANGE to choose Y (Yes) or N (No).
15. Press '. The display shows Remote admin:.
16. Press CHANGE to choose Y (Yes) or N (No).
17. Press '. The display shows Remote monitor:.
18. Press –.
19. Press ≠. The display shows Rem access pkgs.
20. Press '. The display shows Rem line access.
21. Press ≠. The display shows Show line:.
Barring calls and privileges (Restrictions) 89
Compact Plus System Administration Guide