Moving Members Of A Group; Assigning Or Unassigning Lines To A Group - Nortel Modular ICS 4.0 Manual

138 / Programming Hunt Groups

Moving members of a group

Member order within a Hunt Group is important. The member
order determines how a call is routed through a Hunt Group.
1. Place the programming overlay on any M7310 or M7324
ƒ••¤flfl‹››
telephone.
2. Press
‡¤‡fi°‡
The display shows Password:.
3. Press
'
Terminals&Sets.
4. Press
≠
prgrming.
≠
5. Press
6. Press
≠
7. Enter the Hunt Group number you want to program (1-30).
≠
8. Press
9. Press
group.
10. Press MOVE to move an existing member to another place
within the Hunt Group. The display shows the member
number followed by an arrow.
®
11. Enter the new position number for the extension.
12. Press

Assigning or unassigning lines to a group

Configure the prime set for a Hunt Group's line to None to
avoid delayed ring transfer of external Hunt Group calls to the
prime set before the Hunt Group can receive the call.
A line can be assigned to only one group.
Modular ICS 4.0 System Coordinator Guide
until the display shows System
. The display shows Hunt groups.
. The display shows Show group.
. The display shows Member DNs:.
. The display shows the members for that
'
to exit or
(SCPLUS). The display shows
to continue programming.
(CONFIG).
P0881591 Issue 01