Nortel Norstar System Administration Manual page 166

166 Services
Compact Plus System Administration Guide
1. Place the programming overlay over the appropriate keys on
your programming telephone.
2. Press ≤••¤flfl‹›› (CONFIG). The
display shows Password:.
3. Press ‡¤‡fi°‡ (SAPLUS). The display shows
Terminals&Extns.
4. Press ' until the display shows Services.
5. Press ≠. The display shows Ringing service.
6. Press ' until the display shows Routing service.
7. Press ≠. The display shows Routes.
8. Press '. The display shows Dest codes.
9. Press ≠. The display shows Show DstCode:.
10. If there are no codes defined, use ADD, the keypad, and OK to
enter a new destination code (maximum seven). To enter a
wild card character (•) in the destination code, press the ANY
display key.
11. Press ≠. The display shows Normal:.
12. Press CHANGE to select a different route for the destination
code.
13. Enter the three-digit code.
Absorb length
Select the portion of the destination code that is always absorbed
by the system and not used in the dialling sequence.
1. Begin with Normal: (step 11 of the previous procedure).
2. Press ≠. The display shows AbsorbLength:.
3. Press CHANGE.
4. Select the number of digits to be absorbed: 0, All, or any
number up to the length of the destination code.
5. Press ® to exit or ' to programme the next
schedule.
If a telephone number does not match any of the programmed
destination codes, the user must first decide which line to select
and then dial the number. To make this task simple and to ensure
that all long-distance calls are being routed consistently, all area
codes in the United Kingdom numbering plan should be
programmed as destination codes.
P0607114 Issue 01