Programming Routes - Nortel Norstar System Administration Manual

Specifying the type of line to be used

Programming routes

P0607114 Issue 01
Each route allows you to programme the line pool, and, thus, the
type of line to be used as the outgoing facility to reach a
destination. For example, if ISDN lines have been placed in Line
Pool B, specifying pool B as the line pool to use in a route for a
particular destination code ensures that all calls being routed to
that destination use ISDN lines.
You must ensure that extensions and ISDN terminals have access
to the line pools that they need to make calls (programmed under
Line Access in Lines).
See "Chart 19: Routing service" on page 330 in Appendix A for
a programming overview.
Dial Out
1. Place the programming overlay over the appropriate keys on
your programming telephone.
2. Press ≤••¤flfl‹›› (CONFIG). The
display shows Password:.
3. Press ‡¤‡fi°‡ (SAPLUS). The display shows
Terminals&Extns.
4. Press ' until the display shows Services.
5. Press ≠. The display shows Ringing service.
6. Press ' until the display shows Routing service.
7. Press ≠. The display shows Routes.
8. Press ≠. The display shows Show route:.
9. Enter a three-digit route code or press '.
10. Press ≠. The display shows DialOut:.
11. Press CHANGE.
12. Enter the Dial Out digits (up to 24) or press CANCL to choose
No number.
You can press ≤‡° to insert a 1.5-second pause in the
dialling string, if necessary.
Route 000 shows no DialOut:No numbr by default and
cannot be changed.
13. Press OK.
Compact Plus System Administration Guide
Services 163