Programming Handsfree Answerback - Nortel Norstar System Administration Manual

Programming Handsfree answerback

P0607114 Issue 01
5. Enter the extension number of the extension you wish to
programme. The display shows nnn:nnn.
6. Press ≠ twice.
7. Press ' until the display shows Handsfree:.
8. Press CHANGE to choose Auto, Std, or None.
9. Press ® to exit or ' to continue programming.
ATTENTION!
The T7316E keystation must be set to Auto to allow the
handsfree button work. When a call is answered, the
keystation defaults to the last-used answer method.
Handsfree answerback allows you to answer a call without lifting
the receiver. It is always turned off for M1700N/T7000 and
M7000/T7000 telephones.
1. Place the programming overlay over the appropriate keys on
your programming telephone.
2. Press ≤••¤flfl‹›› (CONFIG). The
display shows Password :.
3. Press ¤‹fl›fl (ADMIN). The display shows
Terminals&Extns.
4. Press ≠ The display shows Show extn#:.
.
5. Enter the extension number of the telephone you wish to
programme. The display shows nnn:nnn.
6. Press ≠ twice.
7. Press ' until the display shows HF answerback:.
8. Press CHANGE to choose Y (Yes) or N (No).
9. Press ® to exit or ' to continue programming.
ATTENTION!
The T7316E keystation defaults to the mode that was used
for the last call. For instance, if you use a headset to receive
a call, the next call defaults to the headset.
Programming capabilities 103
Compact Plus System Administration Guide