Touch Screen; Reset Key; User Mode Switch; Fig. 6-2: User Mode Switch - Bosch Rexroth IndraControl VCP 25 Project Planning Manual

R911299720 / 02 | Rexroth IndraControl VCP 25
Display and Operating Components
6.2

Touch Screen

6.3

Reset Key

6.4

User Mode Switch

Electric Drives and Controls | Bosch Rexroth AG
The device is equipped with a resistive 4-wire touch screen. You oper-
ate the small operator terminal using this touch screen.
The reset key is located on the rear of the device. You can use this key
to restart the device.
The user mode switch is located on the rear of the small operator termi-
nal.
The switch positions for ON or OFF are printed onto the user mode
switch.
S1 S2 S3 S4 Operating Mode
I X – – Standard mode with PLC (default upon delivery)
I X I – Standard mode without PLC
I – – I Activate download (erases the application mem-
ory) and default contrast / brightness setting
I – I I Activate upload
– – – – Calibration mask is called-up during start-up
– – I – Calibration mask is called-up during start-up and
the calibration process is started immediately

Fig. 6-2: User mode switch

Legend for table:
I = Switch ON
- = Switch OFF
X = Any switch position
6-3