Redistribute - Dell S4810 Reference Manual

Parameters
ip-address
mask
Defaults Not configured.
Command ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage Although Dell Networking OS does not generate a route due to the backdoor
Information config, there is an option for injecting/sourcing a local route in the presence of
network backdoor config on a learned route.

redistribute

Redistribute routes into BGP.
S4810
Syntax
redistribute {connected | static} [route-map map-name]
To disable redistribution, use the no redistribution {connected | static}
command.
Parameters
connected
static
442
Enter an IP address in dotted decimal format of the network.
Enter the mask of the IP address in the slash prefix length
format (for example, /24).
The mask appears in command outputs in dotted decimal
format (A.B.C.D).
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Enter the keyword connected to redistribute routes from
physically connected interfaces.
Enter the keyword static to redistribute manually
configured routes.
These routes are treated as incomplete routes.
Border Gateway Protocol