Verifying The Firmware Update - Toshiba e-STUDIO4500c Service Manual

April, 2007
NOTE: During operation panel update the screen is blank and the progress bar
is not displayed. To monitor the progress of the operation panel update watch
the [Start] key. While opeation panel update is in progress, the [Start] key LED
flashes RED. The [Start] key lights GREEN when the operation panel update
has completed.
11. Turn the power OFF and ON.
12. Remove the SD card.
This completes the update procedure, but you should do the next procedure to
verify that the update was successful.

Verifying the Firmware Update

This "Verify" procedure is not necessary but is strongly recommended.
1. Open the front door of the copier.
2. With the System SD card in Slot 3, turn the main power switch ON. You see
"Please Wait" and then the door-open alert. The first screen appears after
about 10 sec.
3. Press "Firmware".
4. Select the items that you updated, and then press the [Verify] button.
5. If there are no errors the machine displays the "Verify done" message for each
updated item. Go to the next step.
-or-
If you see "Verify Error" in the first bar on the screen, then you must do the
procedure again for the module shown in the bottom bar. For more details, see
"Errors During Firmware Update" below.
6. After the firmware is correctly updated, turn the main power switch OFF.
7. Push the System SD card in a small distance to release it, then pull it out of the
slot.
8. Turn the main power switch ON, and confirm that the machine operates
correctly.
5-15
FIRMWARE UPDATE