Toshiba e-STUDIO4500c Service Manual page 971

FINISHER JAM DETECTION
Display Mode
R5 to R7 Staple
Booklet
R8 to Staple
R12 (B700
Only)
Jam What It Means
Pre-stack tray After finisher entrance sensor goes ON, pre-
exit sensor lag stack tray exit sensor does not go ON even after
enough time to feed 650 mm.
Pre-stack tray After finisher entrance sensor goes ON, pre-
exit sensor late stack tray exit sensor does not go OFF even after
enough time to feed 1650 mm.
Fold unit The fold unit entrance sensor goes not go ON
entrance after enough time has elapsed to feed 1.5 times
sensor late the length of the stack after the leading edge of
(S26) the stack reaches the stack present sensor
(S32).
Fold unit exit The fold unit exit sensor does not go ON after
sensor late enough time has elapsed for the stack to feed 1.5
(S31) times its length from the fold position.
Fold unit exit After the fold unit exit sensor goes ON, it does
sensor lag not go OFF after enough time has elapsed to
(S31) feed 442.9 mm.
B700-70
August 2006